DRILLOG / Nib / DRILLOG Original Titanium Nib Metal Color 0.5mm

The "DRILLOG" is an innovative pen machined from stainless steel and features precise ink grooves. This is the titanium drill-shaped nib that serves as the hallmark of DRILLOG.

DRILLOG is a writing instrument that uses a unique structure to hold ink or other liquids at the nib, allowing you to enjoy a writing experience unlike any standard pen.
You can vary the expression of your lines depending on the amount of ink used and how you hold the nib.

The nib, created through numerically controlled metal cutting, ensures precise line width. The exquisitely adjusted radius of the nib creates a smooth and comfortable touch.
Made from a titanium alloy, it can be used for a long time without worrying about corrosion, even with slightly acidic or slightly alkaline inks.
The 0.5mm nib width is recommended for a wide range of uses, including delicate lettering and sketching.

After use, you can wash the ink off the nib simply by rinsing it with water.
For a more thorough cleaning, gently scrub with a small brush.
You may also use an ultrasonic cleaner.

※Please note that this item is for the nib only.

・Contents: 1 nib
・Material: Titanium
・Dimensions: Φ7mm, w:37.5mm
・Weight: 4g

＜Precautions for handling the nib＞
・Please ensure the nib does not come into contact with oils, as this may reduce its ink-holding capacity and writing performance.
・The nib has a delicate structure; please be careful not to press the tip down too hard or drop it.
・Use of glitter ink with the 0.5mm nib is not recommended, as ink may not flow from the nib.

●Care and Maintenance of the Nib
Since ink is water-soluble, any oil on the nib will repel the ink and prevent it from adhering.
If ink does not adhere to the nib, please remove the oil using the following method:

＜Method for removing oil from the nib＞
① Apply neutral detergent to a fine-bristled brush (such as a nylon brush or toothbrush), wet it with water, and gently brush along the grooves of the nib.
② Brush each of the eight grooves individually, moving from the tapered section toward the tip of the nib. *Refer to the photo
③ After brushing, rinse off the detergent with running water or warm water and allow it to air dry.
④ After test-writing, if there are any areas where the ink does not adhere to the grooves, repeat steps ① through ③.